Descargar Imprimir esta página

Safety Precautions - Pur Line HA147 Manual De Usuario

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

Get to know your unit.
Read this guide carefully and note all recommended safety precautions prior and after using this equipment; keep
your humidifier in good working condition.
Make yourself familiar with instructions and safety guides related to the use of your unit prior to operation.
Keep this user guide for future reference.
Carton content
Humidifier body
Evaporative pad holder (drum) with pads
Water tank

SAFETY PRECAUTIONS

People or children who have not read this manual or are not use to this kind of product should not be
allowed to use the unit.
Your humidifier is designed to be used with AC current. No other than alternative current should be used
for this unit.
Always switch off and unplug your unit when not in operation.
For more safety, it is recommended to include in the installation a high sensitivity default circuit breaker (30
mA). If you do not know the specifications of your installation, please ask a qualified electrician.. If you do
not have a high sensitivity circuit breaker, we recommend you have one installed.
Before using the humidifier, make sure that it is NOT in the "ON" position and all assembly and installations
procedures have been followed.
Connect the supply cord to an electrical wall socket with ground. (Do not use a non earthed supply like an
extension cord, a light bulb socket..) or others.
Place on/off switch to off position and disconnect from wall socket prior to refilling the unit.
If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or similar
qualified person in order to avoid a hazard.
Read all instructions before using this new appliance.
P1- Unpack unit from packing .
P2 - Completely unravel power cord. Do not damage it .
P3 - Remove adhesive tape from top cover.
P4 - Remove wedge which holds circular foam holder, then remove holder from humidifier taking hold of its axis.
P5 - Place drum inside humidifier.
P6 - Pull slightly outward water tank.
P7 – Place water reservoir in its initial setting.
P8 – Make sure you have set the 2 brackets
the back of the humidifier to allow free
10 cm at the rear of the humidifier.
Locating your Humidifier:
For best results we recommend you locate your unit in the middle of premises. If room if heated by pulsed air
please set unit near source of pulsed air.
Do not place humidifier near furniture, paintings or any other object which humidity could damage.
Connecting to mains
S1 - Before using the humidifier, extend the cord and inspect for any signs of damage, inspect plug and socket
.You should use earth socket.
S2 -Connect the unit to mains (230Volt-50 Hz 10Amps).
Humidifier consumption does not exceed 0.5 Amps (110Wh)
i
GB
i

Publicidad

loading