Front Panel Features - Crest Audio LQ 10P Manual Del Usario

PANEL FEATURES

Front Panel Features

5 5 4 4 7 7
6 6
( ( 4 4 ) ) P P O O W W E E R R L L E E D D
Illuminates when the preamp electronics receive power and
should illuminate when the On-Off Switch is in the ON position
and the AC power cord is connected and plugged into the wall
outlet.
( ( 5 5 ) ) L L I I N N E E I I N N / / T T H H R R U U
The input and output jacks are paralleled to allow the audio input
signal to be daisy-chained to other devices.The "output" level is
the same as the "input" level and there is no isolation between
the various jacks.The input is medium impedance balanced. Jack
(5a) is a combo female XLR and 1/4" RTS connector, and jack (5b)
is a male XLR.
( ( 6 6 ) ) L L E E V V E E L L
Controls the gain of the LQ 10P system.When used with the Line
In/Thru jacks (5), it directly sets the system output level.
( ( 7 7 ) ) L L I I N N K K J J A A C C K K S S
Link Out takes the signal after the balanced inputs and the level
control and allows linkage to another LQ 10P via its Link In jack.
The level control on the first powered speaker now controls the
level of the linked powered speaker.These are unbalanced high-Z
jacks, so do not run the cable very far.
6