Onkyo HT-RC660 Manual Básico página 15

6
Using the multi-zone function
You can multi-zone connect the unit with an integrated
amplifier and speakers in a separate room and play sound
from an external device connected to the analog audio
input jacks of the unit, sound from the "NET", "USB" or
"BLUETOOTH" source, and the AM/FM broadcasting.
It is possible to perform playback in the main room and a
separate room at the same time, for example by playing
the Blu-ray Disc player in the main room where the unit is
placed while playing Internet radio in a separate room. It is
also possible to perform playback only in a separate room.
r As for analog audio input, it is possible to play the
same source or different sources in the main room and
separate room.
r As for the "NET", "USB" and "BLUETOOTH", you cannot
select different inputs for the main room and separate
room. For example, if "NET" has been selected in the
main room and then "USB" is selected as playback
source in the separate room, the input in the main room
will change to "USB" accordingly.
r When listening to AM/FM broadcasting, you cannot select
different stations for the main room and separate room.
Therefore broadcasting of the same station will be heard
in the both rooms.
Connecting with Player
To output audio of the Blu-ray Disc player or such other
player as the source of multi-zone playback, it is necessary
to connect the RCA audio output jacks of the player and the
analog audio input jacks of the unit using the analog audio
cable.
AUDIO
OUT
r Output to multi-zone is not possible if the connection is
only with HDMI cable or digital cable.
r Analog audio output setting may be necessary on the player.
Making multi-zone connection
„ Connecting an Integrated Amplifier in a
Separate Room
You can enjoy 2-channel stereo playback in the other room
during playing 7.2-channel in the main room.
Connect the LINE OUT ZONE2 jacks of the unit and the
line-in jacks of the pre-main amplifier in a separate room
with an analog audio (RCA) cable.
Zone 2
r The volume should be adjusted with the pre-main
amplifier used in the separate room.
Step 3:
„ Connecting speakers in another room
It is possible to directly connect the speakers in another
room without an amplifier. Connect the speakers in another
room to the SPEAKERS ZONE2 terminals of the unit using
speaker cables. Note that 5.2 ch will be the maximum ( ¼ )
in the main room during Zone 2 playback. Sound cannot
be output from the Surround Back speakers and Height
speakers.
¼ In this case, the Dolby Atmos listening mode cannot be selected.
Zone 2
Change the setting: After connecting the speakers, press
RCV and then HOME on the remote controller, select
"Setup" - "2. Speaker Setup" - "Speaker Settings" and set
"Powered Zone2" to "Yes".
r Adjust the volume on this unit. To adjust the volume,
press ZONE2 on the remote controller and adjust with
S T
VOL / . To control on the main unit, press ZONE2 and
within 8 seconds, adjust with the MASTER VOLUME
control. You can mute the sound by pressing MUTING on
the remote controller.
Playing Back
15