Setting The Date And Time; To Set The Time - Oakley ELITE FULL METAL JACKET Manual Del Usuario

6 OAKLEY FULL METAL JACKET INSTRUCTION MANUAL
™

SETTING THE DATE AND TIME

If the timepiece has rested idle for an extended
period and the stored energy is depleted, it can
be started quickly with a few movements of your
wrist. Move it back and forth at a rate of twice per
second. (For more information, see the section on
Powering the Timepiece.)
Full Metal Jacket has a locking screw-down
crown for water resistance. You must unscrew
the crown before pulling it out to the click
positions that let you set the timepiece.
The first click position is for setting the date
and day. The second click position is for setting
the time.
To set the timepiece the first time (or to set it after
it has rested idle for an extended period and the
hands have stopped), do the following:
1. Unscrew the crown from the case. Pull the
crown out to the first click position (a).
2. Turn the crown clockwise until yesterday's date
appears. Turn the crown counterclockwise
until yesterday's day appears.
3. Pull the crown out to the second click position (b).
4. Turn the crown counterclockwise until today's
date and day appear, then continue forward
until the current time is reached. If the current
time is in the afternoon or evening, move the
hour hand all the way around the dial to pass
12 noon.
5. Push the crown back in and gently turn it
clockwise until it screws into the case. Be
careful not to over tighten the crown, as this
will damage the mechanism.
To set the exact second, wait until the hand on
the second-counting sub dial (at the left of the
main dial face) reaches "60" before you pull out
the crown to the second click position (b). Set the
time then wait until the exact second is reached
before pushing the crown back in.
Minute
Hour Hand
Hand
Seconds
Counter
Crown
Second Hand
TO ADJUST THE TIME FOR SUBSEQUENT SETTINGS, USE THESE SHORT PROCEDURES

TO SET THE TIME

1. Unscrew the crown from the case. Pull the crown out to the first click position (a).
2. Pull the crown out to the second click position (b).
3. Turn the crown clockwise until you reach the correct time.
4. Push the crown back in and gently turn it clockwise until it screws into the case. Be careful not to over
tighten the crown, as this will damage the mechanism.
TO SET THE DATE AND DAY (WHEN THE CURRENT TIME OF DAY IS ALREADY CORRECT)
NOTE: Do not use this procedure between 8 PM and 2 AM.
1. Unscrew the crown from the case. Pull the crown out to the first click position (a).
2. Turn the crown clockwise until you reach the correct date. Turn the crown counterclockwise until you
reach the correct day.
3. Push the crown back in and gently turn it clockwise until it screws into the case. Be careful not to over
tighten the crown, as this will damage the mechanism.
Date
Day
OAKLEY FULL METAL JACKET INSTRUCTION MANUAL
™
7