Bulb Replacement - CONFORAMA MILLY Instrucciones De Instalación

24. Blade Fixing Nut
26. Blade Fixing
Flat Washer
27. Blade Holder
29. Blade Fixing Screws
Assemble blade holder onto the blades
by tightening the screws, flat washer,
spring washers and nuts together.

Bulb Replacement

36. Bulb
(not provided)
Install a light blulb (E14 Max.60W,not
supplied) to the lamp holder. Switch the
power on
to check the operation of the
lamp kit and fan.
• Direction Switch on fan body controls air movement:
In cold weather : Push switch RIGHT for the blades to move the warm air trapped near the ceiling.
In hot weather : Push switch LEFT for the blades to create a breeze and circulate the air.
Note: Before using the direction switch, turn the fan OFF and ensure that the fan has stopped rotating to
prevent injury to yourself and damage to the motor.Keep the switch in either LEFT or RIGHT position.
25. Blade Fixing
Spring Washer
28. Blade
Install the fan blade sets onto the motor
by tightening the screws and spring
washers.
15. Glass
Shade
Install the glass shade onto the switch
housing by tightening the three thumb
screws. CAUTION: Do not use pliers to
tighten the thumbscrews. Over
tightening of the thumb screws may
crack the glass shade and cause
dangers.
12. Lamp switch
32. Fan switch
Attach pull cords on fan switch and
lamp switch,ensure that the pull cord
retaining clips supports the cord.
Page4