General Characteristics - Rubi MIX-9 N Manual De Instrucciones

F. MAINTENANCE
Cleaning and maintenance.
- Correct maintenance of the machine will prolong its useful life.
- The lever switch should always be left in the proper function and
in correct condition.
- The mixing tools must be cleaned after use or when they have
not been used for a long time.
- Cleaning is usually effective by using jets of water or quartz sand.
- Do not exert any mechanical pressure on the machine, such as
hard blows, as this could damage it.
- The mixer axis must always be clean.
- The respirator of the motor protective case must never be
covered when the machine is in use
- The respirator should be cleaned frequently.
- Under no circumstances should materials be introduced into the
machine.
- Original spare parts only should be used for the machine.
- The condition of the brush should be checked frequently.
• When the machine has been operating for 60 hours, change
the brush if it is worn out.
• Turn-off and disconnect the machine. Remove brush covers.
(fig.A)
• Take off the plate and change the brush. (fig.B)
Storage.
The unit should be stored in a dry place it is protected against
Freezing.
The start up and shut down of the machine must be carried out
according to the instructions of each country at a collection point
for the correct classification and treatment of materials.
G. GENERAL CHARACTERISTICS
Exploding.............................................................................................Pag.57
Technical characteristics..................................................................Pag. 60
Electric mitring saws for tiles..........................................................Pag. 61
H. DECLARATION OF COMPLIANCE WITH
EEC REGULATIONS
Germans Boada, S.A.
Avda Olimpiades, 89-91
08191 Rubi, Barcelona (Spain)
Declare under our responsibility that the machines:
RUBIMIX-9 N / RUBIMIX-9 N PLUS
described in the documentation provided, conform to the essential
requirements of the Directive: 2006/42/EC, 2014/30/EC, 2012/19/
EC, 2011/65/EC. And comply with the following standards: EN
60745-1, EN ISO 12100, EN 55014-1, EN 55014-2, EN 61000-3-2,
EN 61000-3-3, EN 62321.
Name and address of the person (established in the Community)
compiled the technical file: Carles Gamisans Berenguer
Rubi, 20-04-2016
English
TRANSLATION OF THE ORIGINAL
Without the previous authorisation of GERMANS BOADA
S.A., the partial or total reproduction of this manual, in any format
or by any means or process, is strictly prohibited, whether such
reproduction be mechanical, photographic or electronic.
Any of these activities will incur legal liability and may give rise to
penal action being taken.
GERMANS BOADA S. A. reserves the right to make any
technical modification without previous notice.
Sr. Carles Gamisans
Technical Direction
7.