Description Of The Appliance - Geba Tronic TCS-Cody 1/3 Instruccion De Montaje Y Manejo

P r o g r a m 2
Input / Clearing of a pass code
Input 8-digit
Push key
master code
button
Input of 2-digit
Input 4- or 5-digit
memory location
pass code
e.g. 07 or 28
Fix output
Actuate key
1
key 2 or key 3
The pass code entered is now stored at the memory location
selected and connected to the fixed output !
With this procedure you can allocate 50 different
pass codes to the memory locations 00 - 49 !!
industrial controls
Push key
Sound
2
signal
2 x long
button
Push key
button
Sound signal
1 x long
®

Description of the appliance

The TCS-Cody consists of a decoder and a keyboard. The units are connected by a simple
double-wire cable without a special plug. Programming of the TCS-Cody is possible with the
keyboard and the master code.
Master code:
The master code is an 8-digit numeral code necessary for all programming procedures.
Only after the input of this code the appliance can be programmed according to your per
sonal needs. TCS-Cody is preset by the company with the master code 12345678.
Pass code:
The pass code is either a four- or five-digit numeral code, by which you operate your
door drive unit. You have the possibility to store up to 50 different pass codes, which means
that up to 50 different persons with different pass codes can open the door. If you are
accompanied by another person when entering your pass code you can at first press as
many keys as you like before you finally enter your code. This ensures that no other
person can notice your pass code, but the TCS-Cody recognizes your pass code as
correct!
The TCS-Cody is preset by the company with the pass code 1234 on memory location 01.
The input of a new code has always to be finished by pressing
After you have made yourself familiar with the functions of the appli
ance, please program your personal master code as well as a pass
code with which you replace the pass code which is located on the
memory place 01. Only by this your TCS-Cody is protected against
manipulation!
TIPTOMATIC
Especially for garage doors the TCS-Cody is designed with TIPTOMATIC-timing. After
input of a pass code and within a period of 60 seconds (adjustable) this function allows to
control the door with any key, except for the
the pass code once again. This isolating facility can, however, be interrupted prior to
the expiration of the 60 seconds, by pressing the
Lock-out function:
For reasons of safety during attempts of manipulation the TCS-Cody automatically blocks
for 10 seconds after the input of a wrong pass code which is signalled with a double
sound signal. By choice, you can arrange that the lock-out time can be doubled after any
wrong input until a correct pass- or master code is entered.
The end of the blocking time is signalled by a long sound signal.
industrial controls
.
ATTENTION!!!
button, and without the need to enter
button.
®