Attaching Or Removing Battery Pack - Panasonic EY37C4 Manual De Instrucciones

III.
ASSEMBLY
Attaching or Removing
Battery pack
1. To attach the battery pack:
[Fig.1
Align the highlighted marker
points and attach battery pack.
Slide the battery pack until it
locks into position.
2. To remove the battery pack:
[Fig.1
Push the button and slide the
battery pack forward.
CAUTION
Do not use the 28.8 V battery
pack.
It cannot be attached properly and
may fall out.
IV.
OPERATION
Example of use [Fig.2]
• When hooking and using, take
out the hook (C) stored in the
handle (D). [Fig.3]
IV-1. Illuminate the light
1. Attach the battery pack to the
main unit.
2. Adjustment the handle and
LED light angle.: [Fig.4]
CAUTION
Do not open and close or
rotate this unit for more than
its range of motion.
• Open and close: 0º to 90º
• Rotation: 0º to 270º
3. Press the ON/OFF switch (F)
once to turn on LED light.
Each times press the ON/OFF
]
]
switch (F), the power turns
from high to mid, from mid to
low, from low to off.
Off
High
mode
Middle
mode
Low
mode
NOTE:
• To turn off the LED light,
hold down the switch for a
while.
• Do not use the LED light with
the unit closed.
• When using immediately
after connecting the battery
pack or after not using for a
long time, keep the power
button down until the light
turns on.
CAUTION
• During and immediately after
use, the light emitting
surface and the back side of
the light emitting surface
become hot, so be sure to
hold the side to operate.
[Fig.5]
4. Finish use and store. [Fig.6]
NOTE:
• If the cap (K) is removed,
reinstall it. [Fig.7]
- 11 -
Maximum
luminance
50% of High
mode luminance
10% of High
mode luminance
EN