Publicidad
Idiomas disponibles
Idiomas disponibles
KCE-16300
Hydraulic multi-functional Tool
4.
The head has to be opened by pulling the Latch , slide the transfer into the head, close
the latch completely.
5.
The draw stud is to be used with both Punch and Die.
6.
Thread the Draw Stud into the Punch Head. Note that the end with the shorter threads
is threaded into the Punch Head.
Use the bearing when punching the hole below ￠34.6mm
7.
8.
The Adapter is to be used with all Punch and Dies that are used. Slide the Adapter
down onto the Threaded Stud
9.
Slide the Die onto the threaded Stud so that it slits flat on the Adapter.
10.
Put the work piece with the drilled hole down onto the Die as shown in
11.
Thread the Punch down onto the work piece as tightly as possible.
12.
The turn screw must be turned 180
handle. Open the retract lever for start punching
13.
Pump the activating retract lever until the punch and die have touched together tightly
and cut through the work piece, When the pressure reaches the maximum force, the
system inside will show "Ka" sound, it means the operator can not punch any more.
Make sure the punching completely during the operation to
avoid the scrap remaining the down punch.
14.
Please press the Retract lever to make the pressure relief and return the punch and die
into starting position.
15.
Thread off the Punch, remove the work piece, the Die and the Adapter. Remove the
Draw Stud from the Adapter.
16.
Carefully remove the punched material and its residue.
17.
Open the head by pulling the Latch and take out the adapter.
18.
The turn screw has to be turned 180
activated.
o
while the retract lever is pushed towards the
o
and the handles must be closed until the lock is
Please refer the illustration for CRIMPING PROCESS:
www.grupotemper.com
Publicidad
