Montage Instructions Of 1240 External Motor - THERMEx 1240 Instrucciones De Montaje

Decor 810/830 external motor

Montage instructions of 1240 external motor

2.2 DRiViNg WAll PlUgS iN
Drive 8mm holes on the surface that external motor will be hang. nail
Ø10 mm wall plugs to (a,B) holes. (Photo 13)
2.3 NAiliNg WAll PlUgS
nail hanging screws to 10mm wall plugs with (a,B) 5,5x60 thumb-
screws. there should be 5mm distance between screw head and wall.
Photo 14
2.4 MONTAgE OF Ø 200 MM PlASTic chiMNEY ADAPTOR
Mount Ø 200mm plastic chimney adaptor to air-outlet of external
motor and fix it to the chimney hood with 3,5x9,5 screw. screws are
given with screw set. Photo 15
2.5 hANgiNg OF EXTERNAl MOTOR
holding external motor on its body, hang it to the wall on (l) plates
that you montaged to external motor through a and B points. Photo 16
2.6 MONTAgE OF AlUMiNUM FlEXiBlE DUcTS
17
Mount the aluminum flexible duct on plastic chimney that is on top of the hood. (Photo 6) Mount
the other end of aluminum flexible duct to air-inlet of external motor. (Photo 7 and Photo 9). then
mount one end of the aluminum flexible duct to air-outlet of external motor (Photo 8, Photo 4,
Photo 9) and the other end to the chimney that is used to let air off.in order to prevent aluminum
ducts and chimneys to disconnect because of air circulation, strengthen their connectin using
bracket.
18
Decor 810_830 ekstern_24770.indd 18
18 19
13
14
A B
15
16
A
20
B
30/06/10 07.58