Cleaning And Maintenance - Kampa EVO Series 2 Instrucciones De Uso

• Never place the product near or on flammable
materials, even when cooling down. Keep a
distance of at least 100 cm to flammable
materials.
• The product must stand on a base that can with-
stand heat of up to at least 80 °C. The housing
can become very hot when in use.
• Observe the safety instructions, see chapter
"Safety precautions when handling liquid gas"
on page 7.
Inserting the gas cartridge
WARNING! Explosion hazard
Check that the seal (fig. 4 4. A, page 4)
is in place and in good condition.
1. Proceed as shown (fig. 4, page 4).
2. Do not use excessive force. If the cartridge
lock lever will not push down, check the posi-
tion of the notch (fig. 4 4. B, page 4).
3. If you hear a hissing noise, the gas cartridge
has not been fitted correctly. Release the car-
tridge lock lever and reposition the cartridge.
Igniting the product
WARNING! Health hazard
Do not leave the product unattended
while in use.
1. Proceed as shown (fig. 5, page 4).
2. If the burner does not ignite, repeat the
ignition.
Removing the gas cartridge
WARNING! Health hazard
• Do not transport or store the device
with the gas cartridge inserted.
• Remove the gas cartridge in a well-
ventilated location.
• Ensure that there are no naked flames
in the vicinity.
• Only remove the gas cartridge when
the product is switched off and has
cooled down.
The cartridge may be disconnected even if some
gas remains.
1. Proceed as shown (fig. 6, page 5).
2. Check the content of a cartridge by shaking
and listening for the liquid gas.
3. Refit the protective cap and store the gas car-
tridge in a cool, dry, well ventilated place out
of the reach of children.
4. Check the condition of the seal (fig. 4 4. A,
page 4). Let the seal be replaced by a qualified
person if material is brittle or porous.
Moving and storing the product
WARNING! Health hazard
Do not transport or store the device with
the gas cartridge inserted.
Proceed as follows:
1. Turn off the product.
2. Let the product cool down completely.
3. Remove the gas cartridge from the product
(see chapter "Removing the gas cartridge" on
page 9).
4. Clean the product (see chapter "Cleaning and
maintenance" on page 9).
5. Store the device on a level, stable place out of
the reach of children.

Cleaning and maintenance

Clean the product after each use:
1. Ensure the product is cold.
2. Remove the gas cartridge from the product.
3. Wash the surfaces of the product with hot
soapy water (fig. 7, page 5).
4. Periodically check the burner to see it is free of
dirt like insects or food remains. Use a brush to
clean it.
4445103378 9