Identification And After-Sales Service; Technical Data - Grillo Princess Manual Uso Y Mantenimento

IDENTIFICATION AND AFTER-SALES SERVICE

IDENTIFICATION
The cultivator chassis carries a nameplate with the machine's serial number. This number must be
mentioned whenever you request after-sales service or order spare parts.

TECHNICAL DATA

1. Single-gear model: BRIGGS & STRATTON 5,5 HP - TECUMSEH GEOTECH 50T - HONDA GC160-
GX160.
2. Model with 1 forward + 1 reverse gear: BRIGGS & STRATTON 5,5 HP - TECUMSEH GEOTECH
50T - HONDA GC160-GX160 - ROBIN / SUBARU EX 17.
3. Model PRINCESS III with 2 forward + 1 reverse gear: BRIGGS & STRATTON 5,5 HP - TECUMSEH
GEOTECH 50T - HONDA GC160-GX160.
Start: Pull starter with automatic rewind.
Final drive: sprocket and chain.
Clutch: with control lever on handlebar, acting on belt stretcher.
Handlebar: with vertical and lateral adjustment.
Cultivator head housing: in press-formed plate sections, secured by screws.
Cultivator head: Ø 330 with six hoes plus disk width 80 cm.
Travel wheel: at front, supplied as standard.
Safety devices: Machine cutout on handlebar release, mudguards, handlebars and pulley-guards as
standard; exhaust guard.
Weight: 48 kg; PRINCESS III 62 kg.
Accessories: Combined lister. This implement is designed to form shallow trenches for sowing or
irrigation. It is mounted instead of the foot and fixed with the pin - ref. 3. Use in combination with the
cultivator head for excellent results even on hard ground.
AFTER-SALES SERVICE
This handbook provides instructions for use of the cultivator and for correct basic servicing which the user
can carry out himself.
For all procedures not described in this handbook, contact your local dealer.
SPARE PARTS
Always use original spare parts, as they are the only ones to offer complete safety and interchangeability.
Always state the serial number when ordering.
For engine parts, refer to the specific handbook.
WARRANTY
The warranty conditions are as indicated on the specific warranty card.
The engine warranty conditions are those of its manufacturer.
WE ADVISE YOU TO KEEP THE FOLLOWING SPARE PARTS TO HAND
1 set of belts
1 engine air filter
1 throttle lever
ORDERING SPARE PARTS
Always state the machine serial number and the code number of the part to be replaced.
Contact your local dealer or our own stores. Our address is:
GRILLO S.p.A.
Via Cervese 1701 - 47023 CESENA (FC)
Tel. 0547/633111 - Fax 0547/632011
E-mail: grillo@grillospa.it - Http://ww.grillospa.it
7