Description; Technical Specifications; Plug In The Charger; Install The Batteries - Vokkero 3 slot Instrucciones Para El Uso

1.

Description

The ARF7578 "3 slot battery charger" is used to charge and recharge the Vokkero communication system batteries.
Each charger can simultaneously charge up to 3 batteries, which come up in two different capacity : 1130 mAh &
2260 mAh.
Note 1 : the connection of the ARF7578 "3 slot battery charger" on an IT network is only possible in Norway.
Note 2 : Depending of the destination of use, the ARF7578 "3 slot battery charger" is delivered with an European
or North-American power supply cable. For any other country (European or other) requiring a specific power supply
cable, please use one equipped with a plug conform to the local standards.
2.

Technical Specifications

AC/DC converter unit electrical supply
Operating temperature
Charge duration
Dimensions
Battery lifetime
3.

Plug in the charger

• Connect the power supply unit to the socket located on the left side of the charger.
• Connect the power supply unit to the main.
• When plugged in, the 3 LEDs (at the front of the charger) will first turn orange, then they will turn off one after the
other, and finally simultaneously flash green.
• The charger is ready to be used.
4.

Install the batteries

• Place the batteries on the charger (golden contact facing down).
• When the battery has been detected, the corresponding LED turns red.
• If the corresponding LED doesn't light, check that the battery has been correctly positioned.
100- 240 V ~ 1.5 A- 50 to 60 Hz
5°C to 45 °C (41°F to 113°F)
• 5 hours (batt. 2260 mAh)
• 2.5 hours (batt. 1130 mAh)
L: 143mm * H: 39 mm * W: 75 mm
> 500 cycles
10