Grinder Assembly - Weston 33-1301-W Manual De Instrucciones

GRINDER ASSEMBLY

!
WARNING
cleaning, disassembling or assembling.
1. Remove the Front Ring Nut, Grinding Plate,
Knife and Auger from the Grinder Head
before installing the Grinder Head to the Main
Body.
2. Align the notches on the Grinder Head with
the tabs on the Main body.
3. Insert the Grinder Head into the Main Body
and push the lever on Cam Action Lock into
position
(FIGURE B).
4. Insert the Auger into the Grinder Head,
5. Place the Grinder Knife onto the square
portion of the Auger Pin. The cutting edges
( FIGURE D ).
6. Place the Grinding Plate of your choice onto
the Auger Pin. Make sure the notch of the
Grinder Head (FIGURE C).
7. Turn the Front Ring Nut clockwise onto
the threaded end of the Grinder Head until
it touches the Grinder Plate and is snug. DO
NOT over-tighten the Front Ring Nut.
8. Place the Tray on the upright part of the
Grinder Head. NEVER use the Grinder without
the Tray installed!
ENTANGLEMENT HAZARD: Disconnect power before
FIGURE C).
Auger
Pin
Cutting edges of the Knife facing out.
FIGURE B
FIGURE C
FIGURE D
9