Troubleshooting - Samsung POWERbot SR2AJ90 U Serie Manual Del Usuario

troubleshooting

Symptom
the PoWERbot is not
working at all.
the PoWERbot
has stopped during
cleaning.
Suction power is weak.
the PoWERbot cannot
find the docking
station.
the PoWERbot
suddenly cleans
diagonally.
PoWERbot does not
clean a certain area.
1_SR2AJ90@@U_EN_00740B-00_USA.indd 22
fCheck if the emergency switch is on.
fCheck if all the icons are displayed on the display panel.
fCheck if the POWERbot's battery is depleted.
fReplace the batteries (AAA type) if the remote controller is not working.
fWhen POWERbot is immobilized by an obstacle such as a cord, threshold etc,
pick it up and move it away from the obstacle.
- If any fabric or string is caught in a drive wheel, turn off the emergency switch
and remove the fabric or string before using it again.
fWhen there's too much dust in the dustbin, suction power may get weakened.
Turn off the emergency switch and empty the dustbin.
fIf the intake (on bottom of POWERbot) is blocked by foreign matter, turn off the
emergency switch and remove foreign matter from the intake.
fWhen noise suddenly increase, turn off the emergency switch and empty the
dustbin.
fIf the dustbin is assembled incorrectly, suction power may get weakened. Turn
off the emergency switch and refer to page 17 for reassembling.
fCheck if there's a power failure or whether the power plug is unplugged.
fRemove any obstacles around the docking station that may prevent
POWERbot from returning to the docking station.
fWhen there's foreign matter on the charge pins, charging can be affected.
Clean the foreign matter off the pins.
fCheck if the docking station is installed along the grain of wooden floors or
tiles.
fThe POWERbot may clean in a diagonal direction if it is moving to another area
using the shortest route. It may also move at a diagonal if it made contact with
an obstacles at that angle, if it was charged at the charger at an angle, or if the
grain of the wooden/tile floor skewed is in that direction.
fCheck if the charger is installed near a narrow passage or door, and reinstall it
in the other areas.
- If the charger is installed near a narrow passage or door, the POWERbot
cannot pass through the passage or threshold.
ENGLISH-22
checklist
2015-08-18 오전 10:09:42