Operational Problems; Declaration Of Performance - HWAM F 30/55s Manual Del Usario

HWAM automatic
On a cold stove, the starting point of the feeler is controlled . The starting point on a cold stove is about
30° above horizontal . It should feel easy going and bouncy when you push it, no matter if the stove is
cold or hot . By rising or falling temperatures it must not move at a bound . The damper plates must be
dry and clean and slide together unhindered . Control bars and slide gates may have to be smeared with
WD40 (never oil) .
Surface
Any damage to the coating may be remedied using a special coating repair kit available from your HWAM
dealer .
Guarantee
The guarantee does not cover damage due to insufficient maintenance!
o
pEratIonal problEms
Blackened glass
• The wood is too damp . Only use wood stored for at least 12 months under cover and with a moisture
level not exceeding 20% .
• The doors seals may be not be tight .
• Insufficient secondary air introduced to the pane-flushing system . Push the adjustment bar further to
the right until the glass is burned clean .
• Intermittent firing . Allow the insert to heat through properly .
Smoke in the room when opening door
• The damper in the chimney may be closed . Open the damper .
• Insufficient chimney draft . See section on chimney or contact chimney sweep .
• Soot door leaking or dislodged . Replace or refit .
• Never open door when there are still flames in the wood.
Uncontrollable combustion
• A seal in the door is not completely tight . Replace the seal .
• If the draught is too strong inside the chimney, it may be necessary to set the adjustment bar to
minimum, i .e . to the left .
If problems occur that you cannot fix yourself, please consult your wood-burning stove
dealer.
d
EclaratIon oF
The DoP can be downloaded from our website via the following link:
HWAM F 30/55s www .hwam .com/dop/F30-55s
TM
p
ErFormancE
15