Safety Lock - Hang ups Teeter Contour Power Manual Del Usuario

Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
Securing Your Ankles
• Stand with your back to the Table Bed—do not use the inversion table face-down.
• Step over the Main Shaft, placing your feet on the floor on either side. If closed, grasp the
handle of the Deluxe-EZ Reach Ankle Lock System and press the button at the top, pull
slightly toward you, then push out to open it all the way. Release the handle in the open
position.
• To balance yourself, rest only your lower body against the Table Bed as you slide one ankle
at a time between the Front Ankle Cups and the Heel Cups, placing your feet on the Ankle
Comfort Dial.
• Be sure to slide your ankle in from the side (Figure 5); DO NOT insert your foot as you would
slide your foot into a shoe. Your feet should always be either on the floor or on the Ankle
Comfort Dial; never use any other part of the inversion table as a step (Figures 6 and 7).
• Press your ankles back firmly against the Heel Cups. Rotate the top of the Heel Cups toward
your ankles to increase comfort while inverting.
• Pull the handle of the Ankle Lock System toward your legs and release when the fit is snug
(Figure 8).
• Test the closure by jiggling the handle from front to back to make sure the foot clamps are
locked securely.
• Verify that your pant legs or footwear do not interfere with obtaining a secure closure.
• Use the concept of HEAR, FEEL, SEE
Ankle Lock System click into place;
engaged in its setting; SEE
position.
FAILURE to engage the Deluxe EZ-Reach Ankle Lock System fully could
result in serious injury or death!

Safety Lock

• The Safety Lock allows the table to be deactivated without the need to unplug the power
supply.
• Insert the Safety Key and turn clockwise to disable the lock and engage the motor. The
Safety Lock Key will remain in place when the table is in use (Figure 7).
• Upon completion of your inversion session, turn the Safety Lock Key counterclockwise,
remove from the Motor Housing and store in a secure place for future use.
Inverting
• In the event of a power outage during use, you may have to use a hand crank to rotate the
table upright. (See "Emergency Power Outage Directions" on page 1.4). Practice Manual
cranking to an upright position with a spotter until you are comfortable with the procedure.
Useres who are not able to successfully hand crank to an upright position should NEVER
use the unit without a spotter.
• Ensure there is clearance for the table to rotate without contacting other objects or people.
• TO INVERT, push the rotation control button in the direction of your head (FIgure 8).
For your first few inversion sessions, ask a spotter to assist you until
you are able to find your correct balance setting and are comfortable with
every time you secure your ankles:
FEEL the Ankle Lock System to make sure it is fully
that the Ankle Lock System is secure and does not move out of
!
WARNING
DO NOT deviate from these instructions.
! WARNING
the operation of the table.
HEAR the
1.3