Peavey Classic 50 Manual De Instrucciones página 5

Rear Panel
14
AC POWER INLET (14)
This is the receptacle for an IEC line cord, which provides AC power to the unit. Connect the line cord to
this connector to provide power to the unit. Damage to the equipment may result if improper line voltage
is used.
Never break off the ground pin on any equipment. It is provided for your safety. If the outlet used does
not have a ground pin, a suitable grounding adapter should be used and the third wire should be
grounded properly. To prevent the risk of shock or fire hazard, always make sure that the amplifier and
all associated equipment is properly grounded.
FUSE (15)
The fuse is located within the cap of the fuseholder. If the fuse should fail, IT MUST BE REPLACED
WITH THE SAME TYPE AND VALUE IN ORDER TO AVOID DAMAGE TO THE EQUIPMENT AND TO PREVENT
VOIDING THE WARRANTY. If the amp repeatedly blows fuses, it should be taken to a qualified service
center for repair.
EFFECTS SEND (16)
Output for supplying signals to external effects or signal processing equipment
EFFECTS RETURN (17)
Input for returning signals from external effects or signal processing equipment.
SPEAKER OUTPUTS (18)
Speaker output (1/4") jacks are provided for 16 and 8 ohms. When both jacks are engaged, amplifier
impedance is 8 ohms.
REMOTE SWITCH JACKS (19)
Provided for the connection of the included two switch remote footswitch. Footswitch is used to select
the Lead or Normal channels, and control the boost function. An optional one-button footswitch (not
included, part# 03050680) can be connected to defeat reverb. When using remote footswitch, always
insert the plug fully (second click) to ensure proper operation.
15 16
WARNING: THE FUSE SHOULD ONLY BE REPLACED WHEN THE POWER CORD HAS BEEN
DISCONNECTED FROM ITS POWER SOURCE.
17 18 19