Bobrick B-38030 Instrucciones De Instalación Y Mantenimiento página 3

CHECK DRYER OPERATION:
1. Turn electrical power supply on.
2. Position hands under air outlet, within 100mm (4") of air outlet opening.
3. Dryer should turn on. Warm air should blow from air outlet.
4. Remove hands from under air outlet and dryer should stop (within 2 seconds).
GENERAL OPERATING CONDITIONS:
The following minimum machine operating environmental parameters must be met in order to allow proper dryer
operation:
1. The equipment will operate correctly in its intended ambient operating temperature range, at a minimum,
between +5°C (41°F) and +40°C (104°F).
2. The equipment will operate correctly within a relative humidity environment at 50%RH, +40°C (104°F). Higher
RH may be allowed at lower temperatures. Measures shall be taken by the Purchaser to avoid the harmful
effects of occasional condensation.
3. The equipment will operate correctly up to 2000m (6,560ft) above mean sea level.
4. The equipment will operate in a normal office type Pollution Degree 2 environment.
5. The mains supplies in this equipment are designed to work at +/-10% voltage fluctuation of the marked rating.
MAINTENANCE:
WARNING: Motor laminations are live. Turn electrical power supply off
before doing any maintenance or service to dryer. Electrical power supply
must be off unless dryer cover is secured.
1. Turn electrical power supply on.
2. Position hands under air outlet, within 100mm (4'') of air outlet
opening.
3. If a fault develops, disconnect the electrical supply; a qualified
electrician should be called.
4. There are no serviceable parts on the dryer. Return faulty dryer to
manufacturer noted below.
NOTE: If dryer is installed where there is a lot of dust and dirt in the air,
the interior of the dryer should be cleaned out frequently.
PRODUCT INFORMATION:
Model No. B-38030 230V: 208–240V AC, 3.6-4.0 Amp, 750-950 Watts, 50/60 Hz, Single Phase, VDE approved, CE
Marked, cUListed, Meets Electrical Safety Requirement: AS/NZ 60335.2.23:2004.
Product weight: 16.5kg (36.5 Lbs.)
Spare Parts List:
38030-2 Door Assembly (Upper)
38030-26 Door Assembly (Lower)
4369-175 TowelMate
38030-29 Waste Bin
38030-25 Lock & Key (Cat 74)
38030-23 Lock Mounting Plate Assembly with Tape
38030-36 Dryer Assembly 230V
38030-55 Activation Sensor Assembly
38030-40 Nozzle Assembly, Left
38030-41 Nozzle Assembly, Right
Form No. 38030-69 Revised 6/30/16
Support Rod
®
© 2016 by Bobrick Washroom Equipment, Inc. Printed in U.S.A.