Removing Collected Water - Dandy DDR30B1GB Guía De Uso Y De Mantenimiento Del Propietario

REMOVING COLLECTED
WATER
A1. Pull the bucket out a little
A2. Hold both sides of the bucket with
even strength, and pull it out from the
unit. Pour the water out.
B1.
Drain hose
Adaptor A
B2.
Plastic cover
Drain hose
subassembly
B3.
Connector
Drain hose
B4.
Water hose
Female thread
end
OPERATING INSTRUCTIONS
There are two ways to remove collected water.
A. Use the bucket
When the unit is off, if the bucket is full, the unit will beep 8 times, the
Full indicator light will fl ash, and the digital display shows P2.
When the unit is on, if the bucket is full, the compressor turns off and
the fan turns off after drying the water off the condenser for 30 seconds.
Then the unit will beep 8 times and the Full indicator light will fl ash, and
the digital display shows P2.
To empty the full bucket, slowly pull out the bucket. Grip the left and
right handles securely, and carefully pull it straight out so water does not
spill. Do not put the tank on the fl oor because the bottom of the bucket
is uneven. Otherwise the bucket will fall and cause the water to spill.
Discard the water and return the bucket to the unit. The bucket must
be in place and securely seated for the dehumidifi er to operate. The
machine will re-start when the bucket is restored in its correct position.
NOTE:
When you remove the bucket, do not touch any parts inside of the unit.
Doing so may damage the product. Be sure to push the bucket gently
all the way into the unit. Banging the bucket against anything or failing
to push it in securely may cause the unit not to operate. When you
remove the bucket, if there is some water inside the unit you must dry it.
B. Continuous draining
Water can be automatically emptied into a fl oor drain by attaching the
unit with a ID ≥ 5/16" water hose with a ID:M=1 female threaded
end (not included). Install the drain hose onto the adaptor A as shown in
B1. The adaptor is found in the accessory bag located in the bucket.
Remove the plastic cover from the back drain outlet of the unit and set it
aside. Remove the bucket, then insert the drain hose through the drain
outlet of the unit and securely press it into the connector on the front of
the unit. (See B2.)
Tighten the adaptor A and the unit by using two screws (found in the
accessory bag located in the bucket upon purchase).
Install the female threaded end of the water hose into the adaptor
A. (See B4), then lead the water hose to the fl oor drain or a suitable
drainage facility.
Make sure the hose is secure so there are no leaks.
Direct the hose toward the drain, making sure that there are no kinks
that will stop the water from fl owing.
Place the end of the hose into the drain and make sure the end of the
hose is level or declining to let the water fl ow smoothly. Place the bucket
back in the unit and make sure that it is located correctly.
Select the desired humidity setting and fan speed on the unit for
continuous draining to start.
Accessories (for continuous drain):
Drain hose (1 pc) Adaptor A (1 pc)
9
Screw (2 pc)