Overview of illumination
modes
You can find an overview of the dif-
ferent illumination modes here.
Illumination mode
The LEDs light up
pink.
The LEDs light up
white.
The LEDs flash white
twice.
The LEDs light up
green.
The LEDs light up or
flash red.
The LEDs do not light
up.
Quantity of nutrient solution
Here you can find an overview for the
status of the nutrient solution.
Illumination mode
The LEDs flash white
twice.
Status
¡ The device is in the
sprouting phase.
or
¡ Holiday mode is
switched on.
One or more height
modules are inserted.
The device is in stand-
ard mode.
¡ Manual switch
between sleep
mode and stand-
ard mode is con-
firmed.
or
¡ The maximum ca-
pacity of the water
bowl has been
reached.
Descaling has started
and the pump is run-
ning.
→ "Troubleshooting",
Page 30
→ "Troubleshooting",
Page 30
Status
The maximum capa-
city of the water bowl
has been reached.
Before using for the first time en
Illumination mode
The LEDs light up
blue for 5 seconds
while the pump is run-
ning.
The LEDs flash blue
10 times every
3 minutes. The pump
has switched off.
Before using for the first time
Before using for the
first time
Prepare the appliance for use.
Before using for the first time
Preparing the device
Remove the light unit.
1.
→ Fig.
2
Remove all other parts from the
2.
docking unit.
→ Fig.
3
Clean all parts before using for the
3.
first time.
→ "Overview of cleaning",
Page 29
Put the cleaned and dried parts
4.
out ready for use.
General information
Please bear this information in mind
so that you can get the best out of
your appliance.
Note
Do not install the device under the
following conditions:
¡ in direct sunlight
¡ close to air-conditioning systems
and heaters
¡ outdoors
¡ in areas at risk from frost
¡ in areas with an ambient temperat-
ure exceeding 36 °C
Status
Only a little nutrient
solution remains in
the water bowl.
The water bowl con-
tains too little nutrient
solution. Nutrient solu-
tion should be topped
up.
25