Unpacking; Assemble Wheels; Assemble Rubber Feet; Assemble Quick Conncect - Craftsman 919.167780 Manual Del Operador

Unpacking

1. Remove all packaging leaving the air compressor
on the pallet.
2. Remove and discard the (4) screws holding the air
compressor to the pallet.
It may be necessary to
brace or support one
side of the air compressor when removing
the pallet because the air compressor will
have a tendency to tip.
3. Carefully remove the air compressor from the pal-
let.

Assemble Wheels

outfit when installing the wheels because the
compressor will have a tendency to tip.
1. Attach wheels with shoulder bolts and nuts as
shown.
Nut
Wheel
D22130
Screws
It will be necessary to brace
or support one side of the
Rubber Feet
Screw
Shoulder Bolt
2. Tighten securely. NOTE: The outfit will sit level if
the wheels are properly installed.
clearance, stability or support for pulling
the unit up and down stairs or steps. The
unit must be lifted, or pushed up a ramp.

Assemble Rubber Feet

1. Attach rubber feet with the screws provided as
shown in previous figure.
2. Tighten securely.
8 - ENG
The wheels and handle
do not provide adequate