Samsung RF18A5101 Serie Manual Del Usuario página 29

STEP 6 Connect the water dispenser line (applicable models only)
A water dispenser with a filter is one of the helpful features on your new refrigerator. To
help promote better health, the water filter removes unwanted particles from your water.
However, it does not sterilize or destroy microorganisms. You may need to purchase a
water purifying system to do that.
The water line also connects to the ice maker. For the ice maker to operate properly, water
pressure of 30 to 120 psi (206 to 827 kPa) psi is required.
If the refrigerator is installed in an area with low water pressure (below 30 psi / 206 kPa),
you can install a booster pump to compensate for the low pressure.
After you have connected the water line, make sure the water storage tank inside the
refrigerator is properly filled. To do this, press the water dispenser lever until water runs
from the water outlet.
NOTE
• Water line installation kits are available at extra cost from your retailer. We recommend
using a water line installation kit that contains copper tubing and a
compression nut.
A
B
C
B
Untitled-1 29
1. Shut off the main water source.
2. Insert the pipe clamp (B) and the shutoff
3. Connect the water line installation kit
A
/ " (6 mm)
1
4
valve (C) into the cold water line (A).
(A) to the shutoff valve (B).
English 29
2021-03-09 10:32:20