Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Installation
Pedestal to Bench
Bench to Floor
WARNING
Install only on a level, secure floor
surface. Do not attempt to mount
on wall or other vertical surface.
Insert a stud, thread side up, into each hole.
D
Place a washer and nut (flush) on top of the stud
and tap on the nut with a hammer until seated.
Tighten nut to secure bench(es).
Bradley Corporation • LK-INSTR-003 Rev. D; EN 12-13-001
Position each pedestal on the
A
underside of the bench.
Mark the hole locations and
remove the pedestals.
Using a 3/16" drill bit, drill 1/2"
deep starter holes in the bench.
Lenox Lockers™ Pedestal Bench
(152mm)
B
Secure the pedestals with the
#14 x 1-3/4" screws provided.
Position flanges and mark hole
C
locations on the floor. Remove
the
bench.
Using a 1/4" masonry drill bit, drill
starter holes in the floor 1-1/8" to
1-1/4" deep.
4/4/2012
6"
C L
3
Publicidad
