Fc ( Function ) Selector; Am/Fm Switching; Scan - Albrecht AE 6491 CT Guía De Usuario

Operation

FC ( Function ) Selector

The squelch control knob has an important function, if you press this knob.
• If you press this SQ control knob short, you can start the "second" functions which
are printed in the upper part of each function control button.

AM/FM switching

You can select AM or FM modulation by pressing the AM/FM button.
Please note that in the German 80 CH system it is possible (and allowed) to listen in AM
on all 80 channels, but transmit is only possible on CH 1-40 in AM. During receive mode,
the bar graph shows the strengths of the received signal, during transmission, it shows
the relative output power. In dE and EU settings, the AM power depends on the jumper
setting on the lower printed circuits board side (see country switching)

SCAN

Your AE 6491 CT incorporates a scanning feature. The radio will scan through all 40 (80)
channels and will stop at BUSY channel. It will stay on that channel until seven seconds
after conversation has stopped and then it will resume scanning.
• To start scanning turn on the power first and adjust the volume and squelch.
• Press the SCAN button to start scanning. The word SC will appear in the LCD
• display and the unit will start scanning.
• If you want to stop scanning you can push the scan button again or press the
push to talk switch.
This will shut off the scanning function and transmit on that channel.
30 English