Service And Adjustments - Husky Y6020 Manual Del Operador

ALL MAINTENANCE AND REPAIR OPERATIONS MUST BE PERFORMED
BY TRAINED SERVICE TECHNICIAN.
Before you store the air compressor, make sure you do the following:
1. Review the "Maintenance" section on the preceding pages and perform
scheduled maintenance as necessary.
2. Set the On/Auto/Off switch to "OFF" and unplug unit.
3. Turn the regulator counterclockwise and set the outlet pressure to zero.
4. Remove the air tool or accessory.
5. Pull ring on safety valve allowing air to bleed from the tank until tank
pressure is approximately 20 psi. Release safety valve ring.
6. Drain water from air tank by opening drain valve on bottom of tank.
tank rupture.
7. After the water has been drained, close the drain or drain valve.
NOTE: If drain valve is plugged, release all air pressure. The valve can then be
removed, cleaned, then reinstalled.
8. Protect the electrical cord and air hose from damage (such as being
stepped on or run over). Wind them loosely around the compressor
handle.
9. Store tools and accessories in tool
holder or accessory storage.
10. Store the air compressor in a clean
and dry location.

SERVICE AND ADJUSTMENTS

STORAGE
Water will condense in the air tank. If not drained, water
will corrode and weaken the air tank causing a risk of air
15- ENG
D29616