SEA 23120166 Manual De Instalacion Y Manutencion página 8

RX module working mode description
Remote control self learning (channel/button placement T on exit/exits U1,U2)
- Close jumpers (CH1/CH2) one at time corresponding to exit/exits you want to use.
- Push SW2 for at least 1/2 second, Led will start flashing.
- Activate the button T on the new transmitter.
- The led will emit a long flash and turn off to show that memo procedure is ok.
- Check immediately the memorisation by giving one impulse.
- Check that if no compatible remote control is being activated within 18 seconds from the entrance in self-
learning mode (flashing led), a safety timer will bring the circuit back in normal working mode (the led is off).
Notice: during the self-learning phase of the radio control, place yourself to a distance of
approximately 2 metres from the radio receiver
N.B.: THE BISTABLE EXIT MODES WILL BE SET ON BY LEAVING THE JUMPER CLOSED AFTER THE
LEARNING PROCEDURE IS OVER
Remote control erase
- Take all the jumpers corresponding to exit/exits off.
- Activate learning by SW2.
- Activate the button/channel of the remote control to be erased.
- The led will turn off to confirm that erase is ok.
Whole memory erase
- Push the erase button SW1 for one second at least.
- After release the erase must start.
- The Led will light during the erase procedure and will turn off soon after the procedure is over.
Long distance learning
- Take a remote control (Master) already learnt by the unit.
- Push the remote learning button on the remote control.
- Led must flash.
- Push a whatsoever button of the remote control to be learnt.
- Led must stop flashing after a longer flashing.
Check that all the programming done on the master is being copied on the new remote control.
-
Cod. 67410199
SEA S.r.l. Zona Ind.le S. Atto – Teramo – Italia
Sito Internet: http://www.seateam.com
E-mail: seacom@rgn.it (Uff. Commerciale)
ASSEMBLING THE RECEIVER
1. Antenna
2. Weather gasket
3. Upper box
4. Fixing screws for electronic board
5. Electronic board
6. Fixing base for wall
To assemble follow these instructions:
a) Fix the base to the wall.
b) Insert the 3 o 4 wire cable in the base through the rubber sheath.
If the connection is made with a 3 wire cable, wire link terminal 3
with the power supply negative (terminal 5).
c) Make the connections to the terminal board.
d) Fix the electronic board to the base with the provided screws.
e) Screw the antenna temporally, feed the circuit and follow the TX
programming procedure.
f) Remove the antenna, fix the upper box and screw the antenna
again checking the right position of the gasket in its proper seat.
Rev. 06 , 08/03
seatec@rgn.it (Uff. Tecnico)