Cleaning And Maintenance; Changing The Light Bulb; Cleaning The Condenser - Haier HRZ-186 Manual De Instrucciones

Cleaning and maintenance

Before any cleaning or maintenance is carried out you must disconnect the appliance
from the mains supply by removing the plug, never remove the plug by pulling on the
mains cord. Remove the plug by pulling on the plug itself.
It is recommended that when cleaning the appliance, both the inside and outside, can be
cleaned using warm water and a little bicarbonate of soda. Use 1 teaspoon to 1.2 litres
of water.
If the appliance is not to be used for a long period of time then it is recommended to
remove all the food stuff, clean the inside of the appliance and leave the door open to
allow the air to circulate thus avoiding unpleasant odors.

Changing the light bulb

Note. Light bulbs are not covered by the warranty
Disconnect the appliance from the mains supply.
Pull the lamp cover forwards, to gain accesses to the lamp . Unscrew the light
bulb in an anti-clockwise direction from the holder.
Replace the bulb with one of the correct type and size (10 watt E14 base).
Replace the cover by Pushing the cover Backwards.
Reconnect the appliance to the mains supply.

Cleaning The Condenser

The condenser is the wire pipe work fitted to the rear of the appliance, this condenser must
be cleaned periodically by using a stiff brush or vacuum clearner.
This will ensure correct operation and will save energy, always unplug the appliance before
any cleaning operation.
.
.