Installation - MAXA Mi26 Manual Usuario/Instalador

4. Reinsert correctly the air filter.
● PREPARATION BEFORE USE:
1. Be sure that there aren't obstructions in the air outlet and in the intake vents.
2. Check out whether the ground wire is properly connected.
3. Replace filters if necessary.
● MAINTENANCE AFTER USE:
1. Clean filters and other parts.
2. Turn off the main if the unit is not used.
■

INSTALLATION

1. FAN COIL UNIT'S LOCATION
When select the location of the fan coil unit, take into account the following considerations:
1. The front of the air inlet and outlet has to be free from any obstruction; the outlet air should flow out freely.
2. The wall where the unit is to be mounted should be stiff enough not to vibrate and produce noise.
3. Ensure the clearance on every side of the fan coil unit as per the figure below.
4. Measured from the ground level, the height should be more than the eye level.
>200mm
>400mm
>200mm
3. MOUNTING PLATE'S INSTALLATION
1. After selecting a suitable place for the installation, place the mounting plate horizontally on the wall.
Make sure the alignment is horizontal. Use a plumb line, if available.
2. Mark the location for the wall plugs and the hole for the piping.
Wall plug
Mounting plate
Long screw
3. Drill a 6.4 mm diameter, 32.0 mm depth hole on the wall.
4. Insert the wall plugs.
5. Secure the mounting plate and check for stiffness.
6. Drill a 70.0mm diameter hole either on the right or on the left indoor side and make sure that the hole is slightly slant
downwards.
7. Should the wall be hollow, provide a sleeve for the tube's assembly to prevent dangers caused by mice biting the
connecting cables.
19