Blumfeldt 10029146 Manual Del Usuario página 8

Step 2: Mounting the footrests
The footrest can be moun-
ted easily with 4 screws
(B).
Now place the footstool
gently across the front
opening of the front side.
At the front part of the
lower rack, each guide rail
is bolted to the strip by
means of a screw (C).
Step 3: Construction of the upper rack
To assemble the upper
rack, first screw the side
panels (7) with 4 screws
(A) firmly to the two rear
panel components (8).
The smaller component
is mounted below it, the
hinges facing towards
the ground. On the larger
component, the Velcro
should be facing up.
Using 2 screws (A), fix the
roof panel to the rear wall.
The corresponding points
are marked by arrows.
Optionally, you can attach
the trim on the top basket.
To do so, put together the
parts of the decorative strip
(10) and screw on the up-
per rack using the enclosed
screws (above the awning).
On the footrest, 2 rings
for guide rails (F) are rear
mounted. Please insert the
rail so that the curved end
is the rear.
The curved end of the guide
rail will now be simply
placed back into the pre-
drilled holes.
The cushioning of the foot-
rests can be easily inserted
at an acute angle.
The roof panel (9) is now
attached to the side panels
with 2 screws (A).
To secure the awning ple-
ase use screw (A) with the
plastic clamps (D). Insert
each clamp around the aw-
ning guide and screw in the
screws from inside the side
part at the marked points.
8