W)Lan Connection - oventrop Datalog CS-BS-1 WLAN Instrucciones De Instalación Y Operación Para El Instalador Especializado

Carry out the connection of the device  to the controller / other mod-
ules in the order described below:
Î Connect the data cable (S-Bus, ) to an Oventrop controller . If necessary,
extend the cable using a 2-wire cable (bell wire).


Î Connect S-Bus accessory  via the data cable, if necessary.
If a further S-Bus cable is to be connected, proceed as follows:
Î In order to open the housing, unscrew the screw and remove the upper part
of the housing.
Î Connect the 2-wire cable (bell wire) to the 2 S-Bus terminals (A) and (B) with
any polarity.
Î Close the housing.


Î Connect the device to the mains by means of the mains adapter .
Î For a direct connection to a router, connect the device to a router  using the
network cable (included with the device, ). Or use the WLAN.
26

(A) (B) (C) (D)
Connection terminals of the Datalog
www


3.3

(W)LAN connection

The Datalog CS-BS-1 WLAN can be connected to a router by using a network
cable (CAT5e, RJ45 or similar) or via WLAN (see chap. 4.2 on page 27).
Î Connect the network cable included to the LAN connector of the router and
to the LAN connector of the CS-BS-1 WLAN.
For the next step of commissioning, see chap. 5.2 on page 30.
The LAN connector is located on the front side of the device and supports trans-
fer rates of up to 100 MBit per second.

