Powering The Base; Docking The Headset/Charging; Configuring The Deskphone Audio - Spracht ZuM Maestro DECT Guía De Usuario

Deskphone With an Electronic Hook Switch (EHS)
An EHS adapter enables an incoming call to be answered or
ended by the headset Multi-Function button. EHS cables are
sold separately for certain phones. Please check the Spracht
website for more information.
1. Connect the EHS adapter as shown in the
documentation supplied with the EHS. On some phones
the telephone cable will also need to be connected.
2. Call your connected desk phone using another phone
to activate the EHS adapter. Wait 10 seconds before
answering the phone.

Powering the Base

1. Plug the power adapter into the DC jack marked + 
on the base.
2. Connect the power adapter to a wall power outlet.

Docking the Headset/Charging

1. Press the Multiple Function button on the Headset; the
blue LED on the headset will start flashing every 3s and
the headset will be powered on.
2. Press the Multiple Function button again, or dock the
headset and re-lift it, you will see that the audio link
indicator is on, which confirms the connection between
the headset and base is set up correctly.
3. If docked correctly, the headset battery will begin
charging, if needed (the LED will flash while charging).
Charge for 20 minutes or until the battery indicator LED
shows steady green.

Configuring the Deskphone Audio

Due to the large variety of desk phone brands/models, you
will need to adjust the alignment of ZūM Maestro DECT™
to use it the first time. Adjusting the alignment will enable
the device to function correctly with your specific desk
phone. It is also important to customize the microphone
and receiver volume for your optimal sound quality.
1. Put the Headset on.
2. Get a dial tone by pressing the Headset button on the
desk phone, or by lifting the desk phone handset.
ZūM Maestro DECT™
2