Signature SKSPH3602S Guia De Instalacion página 15

4
Remove the 4 screws holding the blower to the
blower plate. Turn the blower 180 degrees and
reattach it to the blower plate.
5
Position the single blower and blower plate as
shown, tucking the back of the blower plate into
the tabs at the back of the hood. Secure the
blower plate using the 4 screws removed in step
2.
6
Attach an 8" round duct collar or 3 1/4" x 10"
rectancular duct collar to the back of the hood
body using four M3.5 x 8 screws.
INSTALLATION INSTRUCTIONS
7
From inside the hood body, align the top cover
plate to the top of the hood body. Attach the top
cover plate from the outside of the hood, using
four 3/16" x 3/8" screws.
8
Connect the blower plug.
15