kayami MD-12-A Manual Del Usuario página 22

Ambiente sano
OPERATING
INSTRUCTIONS
4
DEFROST
• Turning it on
1. If the device doesn't operate after choosing all the wanted position
and programming it, assure that it is plugged as it should. If this
continues without working, take off the deposit and put it again in
the right position.
2. When the deposit light is On the device will stop working automa-
tically. Retire the deposit, empty it and put it in the right position
once again.
3. When you have made this, the device will continue operating nor-
mally.
4. Assure that the deposit is correctly placed.
5. Plug it.
6. Turn the wheel to the normal position. The device will start opera-
ting. If not, continue turning the wheel until it does. If you want to
reduce the humidity continue turning the wheel until you achieve
the desired position.
The device seizes the humidity of the environment and when it arrives
to the selected level, it stops working. It will continue working when
the humidity level changes again going higher than the desired
level.
7. If for any reason you disconnect the device, wait more or less 3
minutes to put it again.
When the device Works in low temperatures (less than 12ªC)
appears ice inside the device and harms the capacity of the machi-
ne. When this happens, the device will start automatically the de-
frost function. The "Defrost" Light will get on and the device starts
defrosting, when the Light gets off the device will continue operating
normally.