Facom 779.SILR Guía De Instrucciones página 5

OPERATION
- Before first use, charge the 779.SILR inspection lamp for 3 hours.
- When the lamp is in use and charging, the charging time will be longer.
- When charging, the LED on the rear illuminates to indicate charging. Once charging is complete, the LED is switched off.
- If the Charging LED flashes when connected there is a fault, please contact your FACOM distributor.
- To indicate when the battery level is low, when the operating time of the 779.SILR drops to 1/4 hour, the light will flash
off and on twice every 60 seconds.
- The 779.SILC must always be connected to a power source to operate. Please use one of FACOM the adaptors
provided with, or without the 779.SIL-KC, 5m locking Kevlar cable extension.
- The 779.SILC and 779.SILR have two power settings; NORMAL and BOOST:
1. NORMAL : Press the on/off button once and the lamp will turn on in NORMAL mode,
2. BOOST : Press and hold the on/off button for 2-3 seconds when in NORMAL and the BOOST mode will
activate.
- Press and hold the on/off button for 2-3 Seconds when in BOOST mode will return to NORMAL mode.
- Press and release the on/off button in either NORMAL or BOOST mode to switch off.
- Batteries are sensitive to temperature: autonomy variations can occur at low temperatures.
- The 779.SILC and 779.SILR inspection lamps resist most products and solvents used in automotive repair and industrial workshops
(white spirit, petrol, diesel fuel, brake fluid, engine oil).
WARNING
- The LED area of the 779.SILC and 779.SILR can become hot to touch after long periods of use.
MAINTENANCE
- Never immerse the 779.SILC or 779.SILR inspection lamp in a cleaning product.
- Use only FACOM spare battery packs, reference 779.SIL-BP.
- Using non-compliant packs or improper usage can cause leaks or an explosion which would damage the lamp.
- Use only the power adaptors supplied by FACOM.
Li-ion batteries are consumables not covered by the guarantee.
The lamp's autonomy is specified for new batteries.
This product has been designed and manufactured using high quality, recyclable and reusable materials and components.
The crossed wheeled bin symbol applied to the product indicates that it complies with European Directive 2002/96/EC.
Please inquire about the collection of electrical and electronic products in your area.
Please comply with the local regulations. Do not dispose of this product with your normal household waste.
Before disposing of lamp 779.SILR, remove the battery
Battery change procedure :
WARNING: Replace any leaking batteries. Wear goggles and gloves when handling this battery.
Used batteries must be placed in a leak-tight container for recycling in accordance with the local regulations.
779.SIL-LB
+779.SIL-BP
NU-779.0216.indd 5
779.SILR
779.SIL-BP
779.SIL-MA 779.SIL-UC 779.SIL-CA 779.SIL-KC 779.MAG
779.SIL-LC
779.SIL-BP
and comply with local recycling regulations.
Li-ion
779.SILC
2/23/2016 11:58:26 AM