Technical Details - Rollei Steady Butler Action Manual De Usuario

6. App Control
10
• Make sure that your smartphone is connected with the gimbal .
Therefore, please follow the instructions shown in the app .
• Joystick control .
• Setting: Follow Speed, Lock Speed, Rocker Speed, Blind Angle,
Rocker Direction, Motion Time Lapse .
7. Working Mode Instruction
Working Mode Instruction
Panning Mode
Panning and Pitching
Mode
Lock Mode
All Follow Mode

8. Technical Details

Technical Details
Weight
Tilt Rotate Range
Roll Rotate Range
Pan Rotate Range
Angle Vibration Range ±0 .01°
Working Voltage
Battery
Working time
Compatible
Actioncams
*The Bluetooth ® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc . and any use of such marks by Rollei is under license . Other
trademarks and trade names are those of their respective owners . Smartphones not included in delivery . "iPhone" is registered trademark of Apple Inc .
ENGLISH
The actioncam can move to the left or
right smoothly along with the handheld
moving . The pitching and rolling direc-
tions are fixed / locked .
The actioncam can move to left or right
and pitch up and down smoothly along
with the handheld moving . The rolling
direction is fixed / locked .
The actioncam stays in its current
position . The panning, pitching and rolling
directions are all fixed / locked .
The actioncam follows all movements .
The tilt axis, roll axis and pan axis are all
following .
361 g
320°
320°
640°
3 .2V~ 4 .0V
Li-ion battery, 4000 mAh
12 hours
GoPro Hero 6/5/4/3,RX0, YICAM, SJCAM,
or other action camera of similar size
and weight
9. Calibration:
If the gimbal has the following situations, please calibrate it:
– The pitch angle is not levelled with the horizontal surface .
– The roll angle is not parallel to the horizontal surface .
– Under the lock mode, the panning angle is drifting .
Offline Calibration
1 . Turn the gimbal on and wait at least 3 seconds .
2 . Press the mode button for more than 6 seconds until all motors are
stopped and mode light will light up and will be constantly on .
3 .Lay the gimbal on a static flat surface; make sure it has no shaking .
Calibration is finished when mode light is continuously flashing
for 3 times .
4 . Turn off the gimbal after calibration is done .
5 . Turn on the gimbal again and check if the gimbal has now the
correct position . If his is not the case, then do the calibration
operation again until the gimbal works normal .
10. Disclaimer:
1 . Please install and use the product according to the manual!
2 . Please reconfirm the gimbal and the Actioncam are well installed
before turning them on!
3 . Keep the battery away from fire and hot places!
4 . Any illegal purpose while using this device is prohibited . Users
will be responsible for all behavior of purchasing and using the
products .
5 . For any unknown sources or usage, we will not provide any service .