Entretien - Husqvarna ER 105 Manual Del Usuario

1. Connect the product to the power supply with a
cable of type HO7RN-F with one yellow and green
ground cable (A). Make sure there is no tension or
friction.
Remarque : ER 207B, ER 407B and ER 507B have
a 0.6 m/1.9 ft connection cable connected to a plug.
The cable is of type A07RNF 3 x 2.5 mm
AVERTISSEMENT: Make sure that the
connection to the connection box pins
agrees with the "Electrical connection"
instructions on the label.
2. Make sure that the dimension of the connection
cable agrees with the value specified on the rating
plate. Keep the connection cable short. Long cables
can cause voltage drop.
Introduction
AVERTISSEMENT: Lire et comprendre le
chapitre sur la sécurité avant de faire
l'entretien du produit.
Maintenance schedule
Maintenance
Clean the product.
Lubricate the bearings.
Examine the bearings. Replace the
bearings if they are worn or damaged.
Replace the bearings.
1586 - 001 - 26.03.2021
A
2
.

Entretien

Before use, each 10h
X
3. Put the washers in the correct positions. Tighten the
nuts (B) on the connection pins to the correct torque.
Tightening torque à la page 72 .
Refer to
B
4. Connect the ground cable to the connector (C) in the
connection box with a corrosion resistant screw.
5. Install the cover of the connection box tightly.
Each 2 weeks, 75h
Bearing lubrication à la page 72 .
Refer to
X
C
Each 4 weeks, 100h
X
65