Federal Signal Corporation B Serie Instrucciones De Instalación página 5

Ocultar thumbs Ver también para B Serie:
Tabla de contenido

Publicidad

The entire unit is housed in a sturdy box approximately 1-3/4" x 4" x 5-7/8" which can be
mounted to most surfaces by means of #6 screws through the holes provided in the mounting
flanges, with 4-9/16" mounting hole centers.
C. Unpacking.
The unit should be removed carefully from the carton and inspected for any possible damage in
transit. If there is any evidence of damage which might have occurred in shipment, immediately
notify your supplier or the transportation company which delivered it. Claims for damage
sustained in transit must be made upon the carrier. Save all packing material for the claim
agent who will supply you with the proper forms and give you the necessary instructions for
filling out a claim.
D. Specifications.
FCC Registration No:
Phone Line Connector:
Ringer Equivalence:
Ring Detection:
Alert Tone Frequency:
Page Access Time:
Dial Tone Detect Frequency:
Relay Contacts:
Connectors:
High Impedance Output:
600 OHM Output:
Size:
Shipping Weight:
E. Programaming.
1. Security Code Set Up.
The security code allows the user/installer to program the 300PBX-SB. The factory preset
security code is 845464. To program your personal security code, follow the directions below.
a. Call into the 300PBX-SB.
b. Dial * followed by 845464 (a double beep should be heard).
c. Enter your new 6 digit security code followed by, #47 (a double beep should be heard).
Important: It is recommended that the factory set security code be changed. The Security Code can
be reprogrammed only once and can never be changed. This number should be written down and
stored in a safe place.
Note: While programming, if no Touch Tones are entered for 20 seconds, the 300PBX-SB will
disconnect.
2. Programming and Using Remote Access Features (Requires a Touch Tone phone).
If a valid Touch Tone sequence is entered while programming, a double beep will be heard.
Three beeps indicate an error.
To begin programming, call the 300PBX-SB. When the device answers, you have 20 seconds to
enter * followed by your 6 digit security code (a double beep should be heard). The
300PBX-SB may now be programmed.
Note: While programming, if no Touch Tones are entered for 20 seconds, the 300PBX-SB will
disconnect.
HVV USA-34877-KX-N
RJ-11 (2)
0.3B
15.3Hz to 68Hz @ 40V to 150 V.
600Hz.
Programmable, 15 second to 50 minute call timer
400Hz.
220VAC/DC @1 Ampere, Resistive
Terminal Block
47K ohms.
With internal termination, -5db;
without internal termination, -0.5db.
1-3/4" x 4" x 5-7/8"
.95 lb./.431 kg.
-3-

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

300pbx-sb

Tabla de contenido