Mounting Locations - Rockford Fosgate PUNCH RFT3061A Instalación Y Operación

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

CAUTION: If you feel unsure about installing this system yourself, have it installed

by a qualified Rockford Fosgate technician.

CAUTION: Before installation, disconnect the battery negative (-) terminal to

prevent damage to the unit, fire and/or possible injury.

Before beginning any installation, follow these simple rules:

1. Be sure to carefully read and understand the instructions before attempting to install the

Unit.

2. For safety, disconnect the negative lead from the battery prior to beginning the installation.

3. For easier assembly, we suggest you run all wires prior to mounting your Source Unit in

place.

4. Route all of the RCA cables close together and away from any high current wires.

5. Use high quality connectors for a reliable installation and to minimize signal or power loss.

6. Think before you drill! Be careful not to cut or drill into gas tanks, fuel lines, brake or

hydraulic lines, vacuum lines or electrical wiring when working on any vehicle.

7. Never run wires underneath the vehicle. Running the wires inside the vehicle provides the

best protection.

8. Avoid running wires over or through sharp edges. Use rubber or plastic grommets to

protect any wires routed through metal, especially the firewall.

9. ALWAYS protect the battery and electrical system from damage with proper fusing. Install

the appropriate fuse holder and fuse on the +12V power wire within 18" (45.7 cm) of the

battery terminal.

10. When grounding to the chassis of the vehicle, scrape all paint from the metal to ensure a

good, clean ground connection. Grounding connections should be as short as possible and

always be connected to metal that is welded to the main body, or chassis, of the vehicle.