Pushing The Antenna Cable Through The Wall; Incorrect Installation - Kathrein BZD 40 Manual De Usuario

Installation, Connection and Setup

Pushing the Antenna Cable through the Wall

Incorrect Installation

20
Before installing: Before drilling the holes, make sure there are no
electrical cables in the wall.
Danger to life from electric shock!
If you are routing the cable to the outside through the wall, after
pre-assembling the cable, optimising the antenna alignment and
mounting it, as described starting on page 5, carry out the following
steps:
1. Remove the F standard connector
2. Detach the cap from the cable
3. You can now route the cable out through the hole in the wall from the
inside
4. On the outside refi t the cap on the cable, as described on page 5
5. Screw the F standard connector back onto the cable
Cap should be facing downwards - horizontal mounting permitted.
When laying the cable, make sure it is always initially facing downwards.
This will prevent rain from dripping in to the antenna through the cap.