Publicidad
Idiomas disponibles
Idiomas disponibles
1.
FUNCTIONS
FUNCTIONS
CONFIGURATION
CONFIGURATION
WITH REMOTE
WITH REMOTE
CONTROL
CONTROL
• Open the battery
• Insert two AAA batteries
• Close the batteries
2. CONFIGURATION OF THE SENSOR
PARAMETER
KEY
Press the UNLOCK Key (3).
Enter your four-digit access code using NUMBER Keys 0-9 (1).
During the first sensor adjustment or if the access code is reset
UNLOCK
to the '0000' value (factory setting) or during the first minute
after the power-on, press only the UNLOCK Key (3) (no code
required).
UNLOCK with code
When all the parameters have been set, press
the LOCK Key (10).
If you wish to enter a new access code, use NUMBER Keys
LOCK
0-9 (1) to enter the new four-figure code within 20 seconds.
If no access code is entered or if you want to keep the current
access code, press the LOCK Key (10) once more.
If no remote control key is pressed within 1 minute, the
adjustment session is automatically locked.
Pressing the LOCK Key (10) twice within the first minute after
the power-on reset automatically the access code to 0000
value.
LOCK with code change
75.5351.02 EN 20080317 (75.5350)
DESCRIPTION OF THE INFRARED REMOTE CONTROL
compartment at the
back of the remote
control;
supplied with the remote
control as shown beside;
compartment.
Remark: For optimum results point the remote control at the sensor before
Each setting change using the infrared remote control must start with an unlocking and end with a locking
of the
sensor.
It is important to point out that any parameters changed using the remote control
supersede any previous setting.
The table below lists all the parameters, which can be adjusted with the remote control as well as the
operations, required to adjust them.
USER'S ACTIONS
0-9
0-9
0-9
0-9
0-9
0-9
0-9
0-9
pressing its buttons.
UNLOCK without code
LOCK without code or
Code change
FACTORY
LED SIGNAL
SETTING
0000
The red LED flashes quickly waiting
for the access code.
After entering the correct code or if
no code is required, the red LED
flashes slowly to indicate that the
unlock is successful and the
adjustment session has begun.
NOTE:
= Adjustment session ON
0000
The red LED stops flashing to
return to its normal function.
Page 4 of 7
Publicidad
