Fellowes DS-700C Guia De Inicio Rapido página 3

BASIC SHREDDING OPERATION
Continuous operation:
5 minute maximum
NOTE: Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
5 minutes will trigger a
20-minute cool down period.
TROUBLESHOOTING
Paper jam: Set to Off (O) and empty bin. Replace bin and follow any or all of the below procedures.
1
D S - 7 0 0 C
Set to Reverse (R)
for 2-3 seconds
7
BASIC PRODUCT MAINTENANCE
D S - 7 0 0 C
OILING SHREDDER
All cross-cut shredders require oil for peak
performance. If not oiled, a machine may
experience diminished sheet capacity, intrusive
7
noise when shredding and could ultimately
stop running. To avoid these problems, we
recommend you oil your shredder each time
you empty your waste bin.
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.
- 7 0 0 C
D S - 7 0 0 C
LIMITED PRODUCT WARRANTY
LIMITED WARRANTY Fellowes, Inc. ("Fellowes") warrants the cutting blades of the machine to
be free from defects in material and workmanship for 3 years from the date of purchase by the
original consumer. Fellowes warrants all other parts of the machine to be free of defects in material
7 7
and workmanship for 1 year from the date of purchase by the original consumer. If any part is
D S - 7 0 0 C
found to be defective during the warranty period, your sole and exclusive remedy will be repair or
replacement, at Fellowes' option and expense, of the defective part. This warranty does not apply
in cases of abuse, mishandling, or unauthorized repair. ANY IMPLIED WARRANTY, INCLUDING THAT
7
PAPER
1
Plug in and put
disconnect power
switch in ON (I) position
CARD
1 1
D S - 7 0 0 C
Plug in and put
D S - 7 0 0 C
disconnect power
switch in ON (I) position
www.fellowes.com features an extensive on-line support section with a number of self-service options
7
7
2 3
D S - 7 0 0 C
Alternate slowly (approx. 2-3 seconds)
between Reverse (R) and Auto-On (I)
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1
Set to Off (O)
7
2 3
D S - 7 0 0 C
Set to Auto-On (I) Feed into paper
entry and release
7
2 3
Set to Auto-On (I) Hold card at edge
4
Set to Off (O)
and unplug
7
D S - 7 0 0 C
2
7
D S - 7 0 0 C
* Apply oil
across entry
7
D S - 7 0 0 C
15
OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION
TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for
any consequential or incidental damages attributable to this product. This warranty gives you specific
legal rights. The duration, terms, and conditions of this warranty are valid worldwide, except where
different limitations, restrictions, or conditions may be required by local law. For more details or to
obtain service under this warranty, please contact us or your dealer.
4
Set to Off (O)
4
Feed into center of
entry and release
5 6
Gently pull uncut Set to Reverse (R)
paper from paper
entry. Plug in.
3
Set to Reverse (R)
2-3 seconds
7
5
Set to Off (O)
3