Safety Instructions; Set Up; Led Status Indicators - IWS iQ 5 Sync Charge Box Instrucciones Para El Usuario

iQ 5 Sync Charge Box™

Safety Instructions

For your safety – Do not operate the unit if the plug, power socket, power cable or adaptor is damaged.
To reduce the risk of fire, electrical shock and/or injury, the following basic precautions should be followed:
• This device is not intended for use by persons (including children) with reduced physical, sensory and
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instructions concerning the use of the device by a person responsible for their safety.
• CAUTION: To reduce the Risk of Electric Shock – use only indoors.
• Keep away from all sources of water or moisture. Never expose the devices to the rain or dangerous gas.
• The unit may be warm during operation. Keep it in a dry and cool place and do not cover. Ensure
sufficient ventilation at all times.
• Do not overload the socket-outlets.
• Before using the product, check and make sure all devices are correctly and properly connected.
• Arrange the power cord away from traffic areas where it will not be tripped over.
• The unit is powered when the main supply is connected and switched on.
• Remove the supply cords from the iQ 5 Sync Charge Box and adaptor before cleaning. To unplug always
grasp and pull the plug. Never pull the cord.
• Do not try to repair, disassemble or modify the unit. There are no user-serviceable parts inside.
• Do not use the product other than for its intended use.

Set up

1. If the iQ 5 Sync Charge Box is in any packaging, remove this to ensure good ventilation and dispose of
responsibly.
2. If the iQ 5 Sync Charge Box is fitted in a trolley/cart, no relocation is necessary.
3. Insert the mains cord into the power adaptor, and plug the other end into the mains power outlet. Plug
the supply cord into the iQ 5 Sync Charge Box DC inlet. Switch the mains power outlet ON.

LED status indicators

SOLID RED:
FLASHING RED:
FLASHING GREEN:
SOLID GREEN:
FLASHING YELLOW:
SOLID YELLOW:
Power available and ready to charge.
Identifying the best charge profile for the device connected.
Device is charging.
Charging complete and ready to be used.
A host computer is connected but the device is not yet connected.
The host computer and the device are connected. Syncing is now available.