Operating Instructions; Connect Lp Gas Tank; Disconnect Lp Gas Tank; Checking For Leaks - Blue Rhino GBT702 Serie Manual Del Usuario

Recipes
BlueRhino.com/recipes
13
Fold Up Legs
Note: Always lock lid before folding legs.
Unfold Legs
Note: Always open legs completely and are secured in place before lighting.
Need help? 1.800.762.1142
Do not return to place of purchase.
Replacement Parts
parts.BlueRhino.com /
1.800.762.1142

Operating Instructions

This grill is designed to operate with a one pound
7.75" or 10.6" high disposable / 16.4 oz. or 14.1 oz.
propane gas tank (DOT 39 Cylinder) (Figure 1)
DO NOT ATTEMPT TO REFILL ANY ONE POUND (16.4
oz. or 14.1 oz.) PROPANE GAS TANKS!

Connect LP Gas Tank

Only cylinders marked "propane" may be used.
Note: Some 1-lb cylinders may form frost when near
empty.
1. Make sure the regulator/control knob is in the
"LOCK/OFF" position (Figure 2).
2. Lubricate the threads of the regulator/control knob
with petroleum jelly. Line up threads on LP gas tank
with regulator/control knob.
3. Insert and rotate LP gas tank clockwise until they fit
snugly together. HAND TIGHTEN ONLY. Be careful not
to cross threads when screwing in canister
(Figure 3).
4. Test for leaks. See "Checking for Leaks" section.

Disconnect LP Gas Tank

1. Turn the regulator/control knob to the "LOCK/OFF"
position (Figure 2).
2. Rotate LP gas tank counterclockwise until it is loose
(Figure 4).
3. Store the LP gas tank in a proper location, per LP
gas tank instructions.

Checking for Leaks

Burner Connections
1. Make sure the regulator/control knob is securely
fastened to the burner.
Note: The brass nut should be 1/4 to 1/2 turn past
tight. The regulator will rotate 360º even when the
brass nut is tightened.
If your unit was assembled for you, visually check
the connection between the burner and regulator/
control knob (Figure 5).
WARNING: Failure to inspect
this connection or follow these
instructions could cause a fire or an
explosion which can cause death,
serious bodily injury or damage to
property.
2. If the burner and regulator/control knob do not fit
properly or if you have any questions, please contact
1.800.762.1142 for assistance.
Tank/Gas Line Connection
1. Make 2-3 oz. of leak solution by mixing one part
liquid dishwashing soap with three parts water.
2. Make sure regulator/control knob is in the "LOCK/
OFF" position (Figure 2).
3. Spoon several drops of solution, or use squirt bottle,
at all "X" locations (Figure 5).
a. If any bubbles appear remove the LP gas tank and reconnect, making sure the connection
is secure.
b. If you continue to see bubbles after several attempts, remove the LP gas tank per
"Disconnect LP Gas Tank" instructions, and contact 1.800.762.1142 for assistance.
c. If no bubbles appear after one minute, wipe away solution and proceed.
page no.
7
Figure 1
1 lb
1 lb
453 g
453 g
3.875 in. / 9,8 cm
2.9 in. / 7,4 cm
Figure 2
LOCK
OFF
PUSH
TO
TURN ON
Figure 3
Figure 4
Figure 5
X
X