RISCO Group Agility USB232B Guía Rápida De Instalación

General
The USB 232 adaptor converts data between the USB protocol and RISCO Group s Agility panel using the
suitable local bus adaptor (supplied).
Hardware and Software Installation
1. Insert the USB232B Setup CD (supplied) into your computer CD ROM drive.
2. Connect the USB232B converter to your PC's USB port. The setup program will begin to run
automatically.
Note:
When using Windows XP select the No, not this time option from the Found New Hardware Wizard and click the Next
button. On other Microsoft Windows operating systems (Win 98, 2000, NT) proceed to Step 3.
3. Select Install from a list of specific location and click the Next button.
4. Select Search removable media and click the Next button.
5. Windows has finished installing the hardware. Click the Finish button.
6. Once done with the installation of the hardware, you will be prompted to complete the installation
of the software according to the following steps (see the above note if you are using Windows XP
operating system):
a. Select Install from a list of specific location and click the Next button.
b. Select Search removable media and click the Next button.
c. Windows has finished installing the software. Click the Finish button.
7. Make sure the Driver Software installation is accomplished according to the following:
a. Connect the USB232B unit into the USB port of the computer and then click:
Start
b. Verify that the USB Serial Port is listed at Ports (COM & LPT).
8. Changing the COM Port Settings:
a. From Device Manager, select the USB serial port COM option.
b. Choose the Port Settings tab, and then click Advanced.
c. Under the BM options, choose Latency Timer. Set the timer to [1] and click the OK
button.
9. Reboot your system.
USB LED Indications
LED Turns ON when:
Link The USB RS232 is ready for use
TX Data is being sent from the USB port to the panel
RX Data is being sent from the panel to the USB port
USB Wiring
Note:
To enable local communication set the Baud Rate to 38400, Data Bits to 8, Parity to None, Stop bits to 2 and Handshake
to None in the Agility Configuration Software under the Communication Configuration menu. For more information
refer to the Agility Configuration Software Manual.
Quick Installation Guide
Settings Control Panel
USB Adaptor
System Hardware
1
Device Manager
EN