Warning Information - Sunex Tools 6808C Manual Del Propietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING INFORMATION

This is the safety alert symbol. It is used to alert you
to potential personal injury hazards. Obey all safety
messages that follow this symbol to avoid possible
injury or death.
BEFORE USING THESE STANDS, READ THIS MANUAL COMPLETELY AND THOROUGHLY, UNDERSTAND ITS OPERATING PROCEDURES,
SAFETY WARNINGS AND MAINTENANCE REQUIREMENTS.
It is the responsibility of the owner to make sure all personnel read this manual prior to using these stands. It is also the responsibility of
the stand owner to keep this manual intact and in a convenient location for all to see and read. If the manual or product labels are lost or
not legible, contact Sunex for replacements. If the operator is not fluent in English, the product and safety instructions shall be read to
and discussed with the operator in the operator's native language by the purchaser/owner or his designee, making sure that the operator
comprehends its contents.
THE NATURE OF HAZARDOUS SITUATIONS
The use of portable automotive lifting and support devices is subject to certain hazards that cannot be prevented by mechanical means,
but only by the exercise of intelligence, care, and common sense. It is therefore essential to have owners and personnel involved in the use
and operation of the equipment who are careful, competent, trained, and qualified in the safe operation of the equipment and its proper use.
Examples of hazards are dropping, tipping or slipping of loads caused primarily by improperly secured loads, overloading,
off-centered loads, use on other than hard level surfaces, and using equipment for a purpose for which it was not designed.
METHODS TO AVOID HAZARDOUS SITUATIONS
• Read, study, understand and follow all instructions before using.
• This stand is intended to assist in stabilizing a vehicle that is supported by an automotive lift.
• Inspect the stand before each use. Do not use if damaged, altered, modified, in poor condition, or has loose or missing hardware
or components. Take corrective action before using the stand.
• Do not use beyond rated capacity. Do not shock load.
• Use stands in pairs to stabilize the vehicle before starting repairs.
• Use only on a hard level surface capable of supporting the load.
• Users and bystanders must wear eye protection that meets ANSI Z 87.1 and OSHA standards.
• Adequately support the vehicle before starting repairs.
• Center load on saddle. Do not use ends of saddle to support or stabilize load.
• Do not crawl under transmission or place any part of your body under transmission at any time.
• Be sure vehicle and stand are stable before performing any work.
• Failure to heed these warnings may result in fatal personal injury and/or property damage.
• Do not use (or modify) this product for any other purpose than that for which it was designed without consulting the
manufacturer's authorized representative.
WARNING: This product can expose you to chemicals including nickel, which is known to the State of California to cause cancer and birth
defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
CONSEQUENCES OF NOT AVOIDING HAZARDOUS SITUATIONS
Failure to read this manual completely and thoroughly, failure to understand its OPERATING INSTRUCTIONS, SAFETY WARNINGS,
MAINTENANCE INSTRUCTIONS and comply with them, and failure to comply with the METHODS TO AVOID HAZARDOUS SITUATIONS could
cause accidents resulting in serious or fatal personal injury and/or property damage.
6808C
IMPORTANT: READ THESE INSTRUCTIONS BEFORE OPERATING
UNDER HOIST SUPPORT STAND
2
MODEL 6808C
CAPACITY: 2 TON
WARNING: Indicates a hazardous situation
which, if not avoided, could result in death
or serious injury.
rev. 1/22/20

Publicidad

Tabla de contenido
loading

Tabla de contenido