Basic Operation; Turning The Radio On And Off; Adjusting The Volume; Selecting A Channel - Tait Electronics TM8100 Guia Del Usuario

This section describes the basic operation of your radio,
including turning the radio on and off, adjusting volume,
selecting channels, making calls and receiving calls.

Turning the radio on and off

A long press of the on/off key
off. When the radio is first turned on, the red, green and
amber LEDs flash briefly and the radio gives two short beeps.

Adjusting the volume

Rotate the volume control clockwise to increase the speaker
volume and counterclockwise to decrease the volume. The
volume control also changes the volume level of the radio's
audible indicators.

Selecting a channel

Use the channel selection keys
the channel list until the channel you want is displayed.

Making a call

1. Select the required channel using the channel selection
2. Check the green LED.
3. Once the channel is clear (the green LED is off), lift the
4. Hold the microphone about 5cm (2 inches) from your
5. Speak clearly into the microphone and release the PTT

14 Basic operation

Basic operation
keys or
If the green LED is glowing, the channel is busy and you
cannot transmit.
microphone off the microphone clip.
mouth and press the PTT key to transmit.
key when you have finished talking.
Note: You cannot change channels while
transmitting.
turns the radio either on or
or
.
to scroll through