Publicidad
Idiomas disponibles
Idiomas disponibles
LIGHT OPERATION
Installing Or Removing Battery Pack
(See Fig.1, Fig.2)
1. Your new battery pack is not
fully charged. You may need to
charge it before use.
2. Make sure the switch is in the
"off" position before insertion/
removal of a battery pack.
3. To remove a battery pack,
depress both tabs on either
side of the battery and pull
downward .
4. To insert a battery pack, align
the battery with the light
housing and push battery
inward until click indicating
battery is fully installed.
Charging The Battery Pack
(See Fig.3)
1. Battery may not charge when
it is above a certain preset
temperature limit. Allow temperature of battery to cool before
charging.
2. The charge process will take less than one hour.
3. After charging, unplug the charger from the power source and
stow away in a safe place.
MUC122LED2
MUC122LED2 12V PANEL LIGHT WITH TORCH
Fig. 1
Fig. 2
Fig. 3
Light Operation
The cordless light is intended to illuminate a limited work area.
For replacement of LED, return to an authorized Matco
Service Center.
3
rev. 08/13/15
Publicidad
