Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Hookup
Diagram
Guitar
Power Source
Quick Setup
1.
Make sure all items listed on
the front of this guide are in the
Playmate Guitarist's box.
2.
Read the Important Safety
Instructions.
3.
Study the Hookup Diagram
above. Refer to the next section
for details on which cables to
use.
4.
Make sure all devices and
instruments are turned off and
all gain knobs are set to zero.
5.
Connect your guitar to the 1/4"
GUITAR IN input located on the
rear of the Playmate Guitarist.
6.
For maximum control over the
built-in effects, connect an
optional expression pedal to the
1/4" EXPRESSION input.
7.
Connect your headphones to
one of the PHONES jacks. You
may connect two sets of
headphones.
8.
To output the signal to a PA
amplifier, mixer or other
equipment, connect the
Playmate Guitarist's Left and
Right OUTPUT jacks to the
inputs of the device using 1/4"
TRS plugs. To connect to your
stereo, you will need to buy
1/4"-to-RCA plug converters.
9.
Turn on the Playmate Guitarist
first, followed by the other
equipment. Turn on any
amplifiers last to avoid any
sudden "pops" that could
damage speakers.
10. When finished, turn off external
amplifiers first—before turning
off or disconnecting the
Playmate Guitarist—to prevent
damage to speakers.
11. Go to http://www.alesis.com to
register the Playmate Guitarist.
Headphones
GAIN
Expression Pedal
Recording
Digital Audio
Workstation
ADAT
Rear Panel
2
1
3
Rear-Panel Features and
Connection Details
1.
POWER – Turns the unit on
and off. Always use this button
to turn off the unit before
removing the power cord.
2.
IEC Power Plug Connector –
Plug in the power cord that
came with the unit here.
3.
Voltage Switch – Adjusts the
voltage from 115V/60Hz
(American) to 230V/50Hz
(European). It's important that
this is set to the correct voltage;
otherwise, you could damage
the Playmate Guitarist.
4.
GUITAR IN – a 1/4" instrument
input for your guitar or other
instrument.
5.
Gain Knob – controls the gain
of the GUITAR input. Turn this
knob up until you achieve a
loud, clear sound. Turn it down
if you experience distortion,
feedback, clipping or excessive
hiss.
6.
EXPRESSION – a 1/4" input for
an optional expression pedal,
which you can use to control
many of the effects.
7.
PHONES – stereo 1/4"
unbalanced jacks for connecting
two sets of headphones.
8.
L and R OUTPUTS – 1/4" TRS
stereo output for routing the left
and right signals to a device
such as a mixer or amplifier.
Live
PA System
4
7
5
GAIN
8
6
3
Publicidad
Tabla de contenido
