Horizontal Installation; Front Grill Safety Support Assembly - CLIMAVENETA i-LIFE SLIM 102 Instalación - Usuario - Manual De Mantenimiento

HORIZONTAL INSTALLATION

Use the paper template, and trace the position of the two fas-
tening brackets and the two rear screws on the ceiling.
Drill the holes with a suitable drill bit and insert the anchors (2
for each bracket); fasten the two brackets.
Do not fully tighten the screws.
Insert the unit on the two brackets, holding it in position, then
tighten the two screws in the rear anchors, one on each side.
Leave the unit sloping down towards the drain pipe so as to
assist drainage.
Then completely tighten all 6 fastening screws.
A anchors
B brackets
C screws
D drain pipe
FRONT GRILL SAFETY SUPPORT ASSEMBLY (DLMO)
If the fan coil is installed in the horizontal position, to ensure
safety when cleaning/replacing the filters, the installer must
fit the two safety clamps provided in the bag supplied
together with the instruction booklet and the accessories.
A clamps
B spring fastening screws
C grill
8 i-LIFE SLIM EN 05/2013
A B
D
A
For installation of DLMO versions, the horizontal condensate
collection pan kits are available as accessories.
DLRV versions must not be installed horizontally.
Carefully check the slope of the drain pipe.
If the drain line is not sloping downwards, water may
leak from the line.
A
B
These supports are designed to stop the grill from falling.
- Separate the two clamps;
- open the front grill and completely unscrew the spring
fastening screws;
- fasten the two clamps by tightening the screws again;
- fasten the other part of the clamps to the grill, using the
screws supplied;
- close the grill.
B
C
C
A
I A
I A